19-S-03: Operator Crushed in Processor Head

Background

In the summer of 2018 in the Pacific Northwest, a processor operator with ten years of experience died when the delimbing arms and feed rolls of the processor head he was repairing closed suddenly, crushing him.

Incident

As he was operating the processor that day, he noticed that the length-measuring wheel had broken off. He told the yarder engineer that he was going to retrieve it. He got out of the processor, leaving the engine running and the hydraulic switch in the “on” position.

The hydraulic safety lock lever on the processor was broken. When intact, the warning lever extended horizontally from the operator’s seat when the hydraulic system was energized, and it would have to be lowered into the “off” position before the operator exited the cab.

The processor operator and the chaser inspected the damage to the machine. The processor operator asked the chaser for some electrical tape. The chaser gave him the tape and then walked back around the processor to unbell the turn that was coming to the landing.

As the chaser was walking back to the turn, he heard the delimbing arms and feed rolls close on the processor head. He looked back but did not see the operator in the cab. He went back to check on the operator and found him trapped inside the closed head.

The processor operator yelled for help. The chaser called for the yarder engineer, then climbed into the processor and opened the feed rolls. The operator fell out of the head, unconscious. The crew radioed the landowner’s office and emergency services were called. When responders arrived, they pronounced the processor operator dead at the scene.

An investigation found that the processor operator had been standing inside the open delimbing arms and feed rolls placing electrical tape on the wires where the measuring wheel had broken off (see figure 1). The engine was still running, and the hydraulic system was engaged when he started repairs. Grounding one of the wires cut power to the switches that detect that the saws are retracted before allowing a log to be fed (see figure 3). This caused the arms and rolls to close suddenly.

Unsafe Conditions:

The operator did not turn off the processor and hydraulic systems prior to exiting the machine. Before attempting to repair the exposed wires in the processor head, lockout/tagout procedures should have been implemented and the processor head and boom de-energized.

Recommendations for Correction:

  • The safety lock lever was broken. This should have been repaired prior to bringing the machine back in the woods.
  • Lockout/tagout procedures were not followed. The engine was left running, and the hydraulic switch was in the “on” position.

Reviewed by:

Vickie Swanton, FRA Western Region Manager

Originally published by SHARP. Click here for their Hazard Brief.

Operator Crushed in Processor Head IMage 1

Figure 1: Sketch of incident